Table of Contents
Advertisement
A
Only glass approved for 11se i11 Tire CFM
Majestic Prod11cts Company products may be
used for replacement.
I. The use of substitute glass will void all product warranties.
2. Care must be taken to avoid breakage of the glass.
A
Under 110 circ11mstances should this fireplace
be operated wit/rout tire froni glass or with a
broken glass. Replacement of the glass (with
gasket) as supplied by the 111an11fact11rer should
be done by a licensed qualified service person.
'
<
> ,,-.;
'!.,~' ,,:,
'I
- ' •
' ' '
' ' ; '
•
WINDOW FRAME REMOVAL, ..
I. Shut off gas. (See Lighting Instructions)
2. Let the unit cool if it has been operating.
3. Open two side doors.
4. Open the clamps on two sides.
5. Pull the frame foiward.
6. To reinstall window frame follow the above procedure in
~verse.
Release clips
(2 per side)
Fig. 31
<
'
•
'
,,
,1
' .
'
~
•
GLASS CLEANING
• ,,
It will be necessary to clean the glass periodically. During
start-up condensation, which is normal, forms on the inside
of the glass and causes lint, dust and other airborne particles
cling to the glass surface. Also initial paint curing may deposit
a slight film on the glass. It is therefore recommended that
the glass be cleaned two or three times with a non-ammonia
household cleaner and warm water (we recommend gas
fireplace glass cleaner). After that the glass should be cleaned
two or three times during each heating season depending on
'>e circumstances present.
Clean glass after first two weeks of operation.
Refer Figure 32.
I. Remove window frame. (See "Window Frame" section)
2. Remove logs from packaging.
A
As with all plastic - these are not toys and
should be kept away from children and
infants.
3. Place rear log (KR I 0) on rear bracket ( ensure log is seated
properly, leveled and centered to the unit), so it will not
move from side to side and it is firmly positioned on the
bracket.
4. Slip front ember log (KR?) down behind the front deflector.
5. Place front left log (KR8) on top of burner, left side.
Use log's bottom holes to locate it into the left bracket log
locator studs.
6. Place front right log (KR9) on top of burner, right side.
Use log's bottom holes to locate it into the right bracket
log locator studs.
7. Place burner lava rock on top of burner between the ember
log and the two front logs.
8. Place top left log (KR 11) onto locator notches. Ensure log
is secure.
9. Place top right log (KRIZ) onto locator notches. Ensure
log is secure.
Fig. 32
1000 I 948/1 -Page 18 -
Advertisement
Table of Contents
Troubleshooting
