Table of Contents
Advertisement
iiiHii-i
Measure the horizontal length requirement including a 2" over-
p, i.e. from the elbow to the outside wall face plus 2" ( or the
'.stance required if installing a second 90) elbow. (Fig. 21).
Fig. 21
A
Always install horiwntal venting on a level
plane.
~i•Mii
. '1ote: If using the charcoal wall plate, Part #52202-CG, and
collar, Part #52203-CG, put them in place before putting the
pipe sections through the wall.
Use appropriate length of pipe sections - telescopic or fixed -
and install. The sections which go through the wall are pack-
aged with the starter kit, and can be cut to suit if necessary.
(Fig. 22).
A
.
□
f.
J
=
:13
1:
0
..
r;~~Uffi.~~#4~%
Fig. 22
Sealing vent pipe andjirestop gapf with high
temperature sealant will restrict cold air being
drawn in aro1mdfireplace.
111011
Apply high temperature sealant to 4" and 7" collars or the
termination one inch away from crimped end. Guide the vent
terminations 4" and 7" collars into their respective vent pipes.
Double check that the vent pipes overlap the collars by 2".
Secure the termination to the wall with screws provided and
caulk around the wall plate to weatherproof.
½
0
~=()
;;;::;
~
~
.c;==l---,ll,0
' " ' " ""' " ' " "' ' ' ' ' ' ' "
~
A
A
Fig. 23
Support horiznntal pipes every 3 feet (91 cm)
with metal pipe straps .
Check fireplace to make sure it is levelled and
properly positioned.
.
.
.
BELOW GRADE INSTALLATIONS
When it is not possible to meet the required vent terminal
clearances of 12 inches (305mm) above grade level a starter
vent kit is recommended. It allows installation depth of down
to 7 inches (178mm) below grade level. The 7 inches is
measured from the centre of the horizontal vent pipe as it
penetrates through the wall.
A
If venting system is installed below ground, we
recommend a window well with adequate and
proper drainage.
Ensure sidewall venting clearances are observed.
10001948/1 -Page 13 -
Advertisement
Table of Contents
Troubleshooting
