Table of Contents
Advertisement
"Duzy" Gas Log Sets – The Look and Feel of a Real Wood Fire
SAFETY INSTRUCTION FOR MANUAL AND MILLIVOLT CONTROL WITH PILOT
FOR YOUR SAFETY READ BEFORE LIGHTING
A. This appliance is equipped with an ignition
device which automatically lights the pilot.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next
to the floor because some gas is heavier than
air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•
Do not attempt to light any appliance.
•
Do not touch any electric switch; do not
use any phone in your building.
•
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
•
If you cannot reach your gas supplier, call
the fire department.
MANUAL CONTROL LIGHTING INSTRUCTIONS
1. STOP! Read the safety information label.
2. Make sure the manual shutoff valve is fully
open.
3. This gas log set is equipped with an ignition
device (piezo) which automatically lights the
pilot. If piezo ignitor does not light the pilot, see
instructions for "Match Lighting Instructions,"
Page 25.
4. Push in gas control knob slightly and turn
clockwise
to "OFF."
NOTE: Knob cannot be turned to "OFF"
unless knob is pushed in slightly.
5. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the floor. If
you smell gas, STOP! Follow "B" in the safety
information label. If you don't smell gas, go to
next step.
6. Find pilot - follow metal tube from gas control.
7. From "OFF" position, push in gas control knob
slightly and turn counterclockwise
LOT." Push in control knob for 5 seconds.
1. Push in gas control knob slightly and turn clock-
wise
to "OFF". Do not force.
Majestic• VDY 24/18, VDY 30 Gas Log Heater Installation/Owner's Manual • 32D1999 • Rev A • 08/16
24
TO TURN OFF GAS TO APPLIANCE
If you do not follow these instruction
exactly, a fire or explosion may result
causing property damage, personal injury
or loss of life.
C. Use only your hand to push in, or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don't try to repair
it. Call a qualified service technician. Force
or attempted repair may result in a fire or ex-
plosion.
D. Do not use this appliance if any part of it has
been under water. Immediately call a qualified
service technician to inspect the appliance and
to replace any part of the control system and
any gas control that has been under water.
8. With the control knob pushed in, immediately light
the pilot by depressing the piezo and releasing.
Continue to hold the control knob in for about one
(1) minute after the pilot is lit. Release knob and
it will pop back up. Pilot should
remain lit. If it goes out, repeat
steps 5 through 9.
•
If knob does not pop
up when released, stop
and immediately call
your service technician or
gas supplier.
•
If the pilot will not stay lit
after several tries, turn
the gas control knob to
off and call you service
technician or gas sup-
plier.
9. Turn gas control knob
counterclockwise
to "PI-
"ON."
OPERATING INSTRUCTIONS
Control Knob
FP2860
pilot knob
to
Manual
Pilot
FP2849
manual pilot flame
Advertisement
Table of Contents
