Table of Contents
Advertisement
Memories
The trip computer is equipped with two fully automatic
memories.
Fig. 22 Trip computer
display: memory level 1
You can switch between the trip computer 1 and 2 by pressing the
Reset button @ =>fig. 23.
You can tell which memory level is currently active by the number in
the display => fig. 22. The data from the single -trip memory
(memory level 1) is being displayed if a
1
appears. If a
2
is shown,
then the data from the total -trip memory is being displayed
(memory level 2).
Single-trip
memory
(Trip computer
1)
The single-trip memory stores the trip information from the time the
ignition is turned on until it is turned off. If the trip is continued
within 2 hours
from the time the ignition was turned off, the new
data will be included in the calculation of the current trip informa -
tion. If the trip is interrupted for
more than 2 hours
the memory is
reset automatically .
Total-trip
memory
(Trip computer
2)
Unlike the single -trip memory, the total -trip memory is not reset
automatically . This permits you to evaluate your driving data for the
entire period between manual resets . •
Contro ls and eq uip-
ment
Driver
information
display
Operation
The trip computer is controlled by two switches on the
windshield wiper lever.
Fig. 23 Windshield
wiper lever: controls
for the trip computer
Push the function
selector switch up or down
@
~
fig. 23. This will cause the five distinct trip computer
functions
to be displayed one after another.
The trip computer only operates when the ignition is on. When you
turn on the ignition, the function that was in use when you last
turned the ignition off will be displayed.
In addition to the trip computer information
(memory level 1 or 2),
navigation information and Adaptive Cruise Control * information
can be displayed . To switch the display between the different
systems, tap the Reset button @ briefly.
Setting
values
to zero
To delete
one
current value from the trip computer, select the
desired function and press the Reset button @ for at least one
second. The following values can be set to zero
individually
using
the Reset button:
•
elapsed time
•
average fuel mileage
•
average speed
Vehicle care
I
I
Technical data
Advertisement
Table of Contents
