Table of Contents
Advertisement
___________________________________________________
H _ o_ m _ e _L _i _ n _k _® _ R __
l!II
Homelink
®
Universal
remote
control
Ap plies to vehicles: w it h Home lin k® u nive rsal remo te cont rol
General
information
The HomeLink® feature can learn up to three radio
frequency codes for most current transmitters used for
operating garage doors, estate gates, home or outdoor
lighting systems, and other devices.
You must first program the Homelink®
transmitter
before you can
use the system=> page 191, "Programming
the Homelink®
trans-
mitter".
In order to program the Homelink®
transmitter
for devices utilizing
rolling code , a second person on a ladder who can safely reach the
garage door opener motor is recommended.
It is also necessary to
locate the "learn" button on your garage door opener motor . Refer
to the operating
instructions
for the opener, as the location and
color of this button may vary by manufacturer.
You can still use the original remote control for the device at any
time.
&
WARNING
•
Never use the Homelink""
transmitter
with any garage door
opener that does have not the safety stop and reverse feature as
required by federal safety standards. This includes any garage
door opener model manufactured
before April 1, 1982.
•
A garage door opener which cannot detect an object, signaling
the door to stop and reverse does not meet current federal safety
standards . Using a garage door opener without
these features
increases risk of serious injury or death.
Controls and equip-
ment
&
WARNING (continued)
•
For safety reasons never release the parking brake or start the
engine while anyone is standing in front of the vehicle.
•
A garage door or an estate gate may sometimes
be set in
motion when the Homelink®
remote control is being
programmed.
If the device is repeatedly activated, this can over-
strain motor and damage its electrical components
- an over-
heated motor is a fire hazard!
•
To avoid possible injuries or property damage, please always
make absolutely certain that no persons or objects are located in
the range of motion of any equipment
being operated. •
Ap plies to vehicles : wit h Home li nk® uni versal remote con tro l
Programming
the Homelink
® transmitter
The transmitter is programmed in two phases. For rolling
code transmitters, a third phase is also necessary.
f (
~ ~
i
s:
0
,1,
..,
Cl)
l l
Fig. 213 Overhead
console: Homelink®
keypad
~
Advertisement
Table of Contents
