-
Audi lan e as si st
----------------
I \ Not ready: The yellow ind icator light shows that the system is
t urned on but unab le to send a warning . This can be due to the
following:
•
There are no boundary lines, or there is on ly one boundary line
present .
•
The boundary lines are not detected (e.g. due to snow, dirt, wet
conditions or light shining into the camera lens) .
•
More than two boundary lines (such as at construction
sites) are
located in the vehicle's lane .
•
The vehicle's speed is below the speed needed to activate it,
which is abou t 40 mph (65 km/h).
•
The lane is narrower than about 8 ft . (2.5 m), or wider than about
16
ft .
(5 m).
•
The curve is too sharp .
No tes on th e in str umen t clu ste r di s pla y
When the lane assist turns off automatically , the instrument cluster
indicator goes out and one of the following
messages appears on
the display:
Audi lane assist not available: Currentl y no sensor vision
This message appears when the camera can no longer function
because it cannot detect the boundary lines. This may be due to the
following :
•
The exterior side of the camera viewing window => page 151,
fig . 169 is covered with dirt or ice. Clean this part of th e windshield.
•
The camera v iew ing window is fogged up on the inside. In t his
case, wait until the fog disappears before turning lane assist on
aga in.
•
The system was unable to detect boundary lines over an
extended period of time due to road conditions (such as snow-
covered lanes). Do not turn lane assist on again unti l the lines can
be more easily detected .
Audi lane assist not available
A temporary malfunction
is preventing lane assist from operating .
Try turning on lane assist again at a lat er t ime.
Audi lane assist : syst em fault
The system should be checked by an authorized Audi dealer or other
qual ified workshop .
[ i ]
Tips
•
Make sure that the camera viewing window => page 151, fig . 169
is not covered by stickers or similar objects .
•
A lways keep the camera view ing w indow clean . This can usual ly
b e don e by op erat ing the windshield wipers. •
App lies to ve hi cles: w it h lane ass ist
MMI
settings
You can use the MM/ to adjust the warning time and
steering wheel vibration.
Setting
the warning
time
-
Press the [ CAR ] function button.
- Select Systems in the
CAR
men u.
- Select Audi lane assist.
Fig. 170 M M I Display:
Settin g th e w arning
t im e and steering
w heel vibrati on