Table of Contents
Advertisement
lll'I....__
E _m _ e _ r-= g'-- e _n _ c-= y _ s _i_ t _ u _ a _ t_ i_ o _ n _s _______________________________________________
_
- Screw the towing loop tightly into the threaded hole as
far as it will go. The check mark must be flush with the
bumper=>
page 367,
fig. 300.
When it is no longer needed, unscrew the towing loop and put it
back into the vehicle toolkit. Be sure to have the towing loop stored
in the vehicle at all times.
When installing the grill fo r the air duct, be sure that the tabs on the
grill are first inserted into their guides on the vehicle by the
foglamp. Then push the grill into position.
&
WARNING
If you do not screw the towing loop completely, it could come out
of the threaded hole while the vehicle is being towed causing
damage to the vehicle and possible serious personal injury. •
Rear towing
loop
Do not install the rear towing loop until it is needed.
0
Fig. 301 Rear bumper:
cover
"'
Fig. 302 Rear bumper:
towing loop inserted
On the right side of the rear bumper there is a threaded hole
for the towing loop. The threaded hole is behind a cover.
-
Remove the towing loop from the vehicle tool kit.
-
Place the screwdriver against the upper edge of the
cover and carefully pry it out=> fig. 301.
-
Screw the towing loop tightly into the threaded hole as
far as it will go. The check marking must be flush with the
bumper => fig. 302.
When it is no longer needed, unscrew the towing loop and put it
back into the vehicle toolkit. Be sure to have the towing loop stored
in the vehicle at all times.
&
WARNING
If you do not screw the towing loop completely, it could come out
of the threaded hole while the vehicle is being towed causing
damage to the vehicle and possible serious personal injury. •
Advertisement
Table of Contents
