Table of Contents
Advertisement
__________________________________________
A _d_ v_ a _n _c_ e _ d _ P _ a _r _ k _i_ n -= g ;.._ S ...: y '-- s _t _ e _m __
......
Fig. 201 MMI Display:
Contact of the blue
curved line with the
curb
-
Find a parking spot on the right side of the road, for
example .
- Switch on the Adaptive Air Suspension => page 21 stan-
dard or automatic mode.
-
Position your vehicle parallel to the edge of the road,
approximately
3 ft (1 ml away from a parked vehicle
=> page 173, fig. 195. When parking next to obstacles,
please note => page 178.
- Activate the Audi parking system => page 170. "Parking
mode 1" is displayed by default.
-
Press the control button with the mode @ => page 175,
fig. 199 function. "Parking mode 2" => page 176, fig. 200
appears in the MMI Display.
-
Back up in reverse gear and adjust the position of your
vehicle in such a way, that the dark blue surface indicated
in the MMI Display ® => page 176, fig. 200 borders on
the vehicle behind, or the parking spot line. If you are
not
parking next to any obstacles => page 178, the long side
of the dark blue surface should border on the curb. The
entire dark blue surface has to fit into the parking spot
=> page 773, fig.195 .
Contro ls
a nd eq ui p-
ment
While the vehicle is stationary, turn your steering wheel
to the right as far as it will go.
-
Back up into the parking spot. If you are
not
parking next
to any obstacles => page 178, the dark blue bend ©
should touch the curb => fig. 201. Stop your vehicle.
- While the vehicle is stationary, turn your steering wheel
in the opposite direction (left) as far as it will go.
-
Continue to back up into the parking spot until the
vehicle is parked parallel to the curb. When backing up,
also keep an eye on the vehicle front =>
0 .
With "parking mode 2", you can park on the left and right side of the
road. For this reason, the blue surfaces and curved lines are
displayed in different shades of blue . The dark blue surface
G)
and
the dark blue curved line © can be used to park on the right side of
the road . The light blue surface
G)
and the light blue curved line ©
can be used to park on the left side of the road.
When the turn signal is switched on, only the necessary surfaces
and curves are shown. To change the side that is shown, simply
change the turn signal.
The displayed light blue © or dark blue © curved line identifies the
turn -around point when maneuvering to park. If the curved line
touches the curb, the steering wheel turn-around point has been
reached
~
fig.
201 .
The distance from the rear bumper © to the red line © is approxi-
mately 1.3 ft (40 cm). Here, at the latest, you should stop backing up
~
page 179.
in.
WARNING
Please note that objects not touching the ground can appear to be
further away than they really are (for example, the bumper of a
parked vehicle, a trailer hitch, or the rear of a truck). In this case,
..,_
Vehicle care
I
I
irechnical data
Advertisement
Table of Contents
