Mitsubishi MELSEC-Q Series User Manual page 53

4 PREPARATORY PROCEDURES FOR DATA LINK
5)-2 When using a connector for T-branching
After removing the sheath 7cm or more, make a T-branch wiring with a connector in the same way as
the T-branch method for the dedicated flat cable.
6) Make a T-branch wiring with the connector in the same way as the T-branch method for the dedicated flat
cable.
Connector for dedicated flat cable
7) Cut off the 2 portions of the covers
edge with nippers and remove the
edge.
Cut
4 - 13
Connector for VCTF cable/
High flexible cable
Connector for VCTF cable/
High flexible cable
(c) T-Branching procedure (Trunk line: Dedicated flat cable, Drop
line: VCTF cable/High flexible cable)
Connector for VCTF cable/
High flexible cable
(d) Processing procedure for VCTF cable/High flexible cable
connector (Connecting terminating resistor)
8) Place the cover at the point
where the terminating resistor
is to be connected.
VCTF cable/High flexible cable (Trunk line)
VCTF cable/
High flexible cable(Drop line)
Dedicated flat cable (Trunk line)
VCTF cable/
High flexible cable(Drop line)
MELSEC-Q
9) Follow the step (a) 3) and 4)
and execute press-fitting.
4 - 13