Mitsubishi MELSEC-Q Series User Manual page 50

4 PREPARATORY PROCEDURES FOR DATA LINK
1) Properly place the dedicated flat cable
in the cover. (Check that the position
of the orange part is correct.)
Orange
Note 1) This setting position is wrong.
5) Cut 2 portions of the edge of the cover
with nippers and remove the edge.
Cut
4 - 10
(1) Operating steps
The operating steps are illustrated below.
(a) Processing Cable End
2) Close the cover so that the flat cable
will be held between both sides of the
cover.
Note 2) If the orange part is seen through
the guide hole in the front cover,
Orange
the wiring is not correct. Open
the cover and perform the
previous step again.
Orange
(b) T-Branch Processing
6) Set the cover at the point where
T-branch is to be set.
Orange
3) Assemble the cover with the body and
press-fit them with pliers.
Orange
4) Check that all of four latches are
engaged. Press-fitting is completed.
7) Follow the instructions of steps 3 and
4 shown above to execute press-fitting.
Orange
MELSEC-Q
Orange
Orange
4 - 10