SERIAL NUMBER LOCATION
Serial
Number Tag
TEXT AND ILLUSTRATIONS
The arrangement of this parts catalog is for easy identification of parts. All parts are illustrated in exploded
views in proper relation to each other. Some diagrams refer to other pages for further information. Reference
numbers used in the illustrations refer to line numbers in the part lists. The part lists appear to the right or below
all diagrams and correspond with those diagrams. Included in the part lists, along with the reference numbers
are part numbers, part descriptions and the quantity of the part required per Wrap Twine Remover System.
ABBREVIATIONS
SN
"Serial Number" refers to the serial number given to each WTR410/WTR510 by Hillco Technologies. See
above for the Wrap Twine Remover System's serial number location. This abbreviation is used interchangeably
in both instances. Each Model WTR410/WTR510 uses the following serial number format:
xxxx (sequential numbers).
ASM
"Assembly" refers to a whole grouping of parts (shown in the diagram corresponding with the page where
"ASM" is shown unless otherwise noted). Some assemblies have parts that are sold separately, however some
must be purchased as a single unit. Hillco Product Specialists will be able to assist you with any questions.
NS
"Not Shown" refers to a part that is not depicted in the illustration.
RIGHT AND LEFT IDENTIFICATION
The reference to right-hand and left-hand in this catalog is identified by the operator sitting in the operator's seat,
looking toward the front of the machine (in normal forward travel).
PART ORDERS
Orders must specify product model, serial number, correct part number, complete description, quantity required,
method of shipment, shipping address, and billing address.
D-211027DMC01
General Information
3
November, 2023