Table of Contents
Advertisement
Step 9:
Connecting arm cylinder hoses:
Remove the rear cover from the side of the hook
arm to gain access to the hydraulic cylinder inside
the arm.
Route the hoses from the center frame, over the
top of the guides and through the two holes in the
top of the arm. Connect them to their correspond-
ing ports on the arm cylinder. The ends of the
hoses are different to prevent connecting them
incorrectly. Note that you may have to loosen the
fittings in the cylinder to adjust them to the proper
angle.
Zip tie the hoses to the guides then tighten all con-
nections near the arm cylinder. Reinstall the rear
arm cover then repeat this process for the oppo-
site side.
D-211027DMC01
November, 2023
28
Advertisement
Table of Contents
