Hillco WTR410 Operator's Manual / Parts Book page 25

Lower the center frame with your loader tractor
and position the arm near the right side mount
plate so that it can be bolted in place. There are
two positions to install the arms. The narrow posi-
tion (shown) is optimal for round bales, while the
wide position is intended for large square bales
that are 8 feet long or longer.
If using the narrow position, make sure the red
indicator rod will pass through the guide hole the
arm mount. Install all bolts with the nuts at the
rear and tighten with an impact wrench. Make
sure to hit each bolt multiple times to verity they
are properly tightened.
Remove the screw driver from from the knife car-
tridge lip.
D-211027DMC01
25
November, 2023