Hillco WTR410 Operator's Manual / Parts Book page 26

Step 7:
Installing the Hook Arm
Cut the zip tie holding the arm hoses to the mount-
ing plate and set them aside.
Position the hook arm on the shipping pallet and
alight it with the left side mount. As with the right
side, there are two positions for mounting the arm.
Typically, the arms are mounted into the same
position on each side but this is not required.
Install the bolts with the nuts facing the rear of the
unit and tighten with an impact wrench. Again,
tighten each bolt multiple times to ensure they are
all tightened properly.
D-211027DMC01 November, 2023
26