Hillco WTR410 Operator's Manual / Parts Book page 18

Set the cartridge on a sturdy work surface. The
hooks can be removed one at a time by removing
the two bolts that attach them to the pivot frame and
actuator arm. It is recommended that you replace
the bushing when replacing the hook.
When re-installing the hooks, tighten the bolt (A)
that passes through the pivot bushing snugly but
only tighten the bolt (B) on the actuation arm tight
enough that the bolt can still be turned freely by
hand. If the bolts to the actuation arm are too tight
the mechanism can bind.
Assembly is the reverse of the process above.
A
B
D-211027DMC01 November, 2023
18