Table of Contents
Advertisement
Cloud LED
NOTE: To utilize the Cloud LED, download the necessary tools and drivers from www.dell.com/support.
One unique feature of the Edge Gateway 5000 Series is the Cloud LED. Cloud LED enables you to visually inspect the operational
status of the Edge Gateway by looking at the display light on the left panel of the Edge Gateway.
To enable this feature, you must expose and program a GPIO register on the Edge Gateway.
Follow these steps to control the Cloud LED on the Edge Gateway:
1.
Download the Cloud LED utility from https://www.dell.com/support/home/us/en/04/drivers/driversdetails?driverid=9mfpj.
2.
Extract the following files:
a.
DCSTL64.dll
b.
DCSTL64.sys
c.
CloudLED.exe
NOTE: These files must be in the same directory.
3.
Run CloudLED.exe from command prompt or PowerShell with administrative rights. Run the following commands:
•
CloudLED.exe ON
•
CloudLED.exe OFF
TPM support
Windows 10 IoT Enterprise LTSB supports TPM 2.0. For more information on TPM resources, see
us/library/cc749022(v=ws.10).aspx
System Shut down and Restart
1.
Click the Start icon.
2.
Click Power then select Restart or Shut down.
LAN/WLAN network configuration
1.
Click the Start icon.
2.
Type Settings and click Settings.
3.
Select Network & Internet.
WWAN network configuration
Follow the Service Manual to install and configure the WWAN module and the corresponding carrier SIM card for the system. After
the WWAN module and the SIM cards are installed:
1.
Click the Start icon.
2.
Type Settings and click Settings.
3.
Select Network & Internet
4.
Locate the WWAN connection in the Wi-Fi section and select the entry to connect and disconnect from the WWAN adapter.
Bluetooth configuration
1.
Click the Start icon.
2.
Type Settings and click Settings.
3.
Select Devices from the Settings menu and, then select Bluetooth from the menu on the left panel.
https://technet.microsoft.com/en-
31
Advertisement
Table of Contents
