Introduction - Texas Instruments ADC12DL 00 Series User Manual

Trademarks
Trademarks
Keysight ™ is a trademark of Keysight Technologies.
Trilithic ™ is a trademark of Trilithic, Inc..
K&L Microwave ™ is a trademark of K&L Microwave.
SEARAY ® is a registered trademark of Samtec.
Microsoft ® and Windows ®
Rohde & Schwarz ® is a registered trademark of Rohde & Schwarz GmbH & Co..
All trademarks are the property of their respective owners.

1 Introduction

The ADC12DLXX00 is a dual-channel, 12-bit ADC, capable of operating at sampling rates up to 3.2 Giga-
samples per second (GSPS) and 2.5 GSPS in dual-channel mode, or 6.4 GSPS and 5 GSPS in single-channel
mode. The ADC12DLXX00EVM device output data is transmitted over a high-speed LVDS interface. This
evaluation board also includes the following important features:
• Transformer-coupled signal input network allowing a single-ended signal source from 500 kHz to 9 GHz
• The LMX2582 clock synthesizer generates the ADC sampling clock
• Transformer-coupled clock input network to test the ADC performance with an external low-noise clock
source
• LM95233 temperature sensor
• Device register programming through USB connector and FTDI USB-to-SPI bus translator
• High-speed LVDS data output over a 400-pin SEARAY
While this is the same connector used for FMC standard boards, the LVDS data, clock and strobe
pinout is proprietary to the ADC12DL3200EVM, TSW14DL3200EVM, and other compatible boards.
FT4232
(USB to Serial
ADC12DL3200
Interface)
2 ADC12DLXX00 Evaluation Module
are registered trademarks of Microsoft Corporation.
(PLL/VCO ADC
clock source)
LM95233
(Temperature
Monitor)
400 pin
SEARAY
(LVDS Data
Connector)
Copyright © 2023 Texas Instruments Incorporated
® interface connector
Note
LMX2582
TM
SLAU776A – MAY 2018 – REVISED DECEMBER 2023
www.ti.com
Submit Document Feedback