Table of Contents
Advertisement
Quick Links
INSTALLATION AND OPERATION MANUAL
IMPORTANT!
Read all instructions in this manual before operating pump.
As a result of Crane Pumps & Systems, Inc., constant product improvement program,
product changes may occur. As such Crane Pumps & Systems reserves the right to
change product without prior written notifi cation.
A Crane Co. Company
420 Third Street
Piqua, Ohio 45356
Phone: (937) 778-8947
Fax: (937) 773-7157
www.cranepumps.com
Manual Index
CLOSE COUPLED
CENTRIFUGAL PUMPS
Series: "B"
Sections 150 & 350
83 West Drive, Bramton
Ontario, Canada L6T 2J6
Phone: (905) 457-6223
Fax: (905) 457-2650
Form No. 119976-Rev. E
Advertisement
Table of Contents
Related Manuals for Crane WEINMAN Sections 150
Summary of Contents for Crane WEINMAN Sections 150
- Page 1 Read all instructions in this manual before operating pump. As a result of Crane Pumps & Systems, Inc., constant product improvement program, product changes may occur. As such Crane Pumps & Systems reserves the right to change product without prior written notifi cation.
-
Page 2: Safety First
(fl ammable, caustic, etc.) unless the pump is specifi cally designed and designated to handle them. Other brand and product names are trademarks or registered trademarks of their respective holders. Weinman® is a registered trademark of Crane Pumps & Systems, Inc. 8/2004, 3/4/2005, 5/06, 9/06 Alteration Rights Reserved... -
Page 3: General Information
Shaft turns freely. Systems, Inc., Service Department in Piqua, Ohio, telephone Rotation is correct. The pump must rotate in the (937) 778-8947 or Crane Pumps & Systems Canada, Inc., direction of the arrow on the casing. Bramton, Ontario, (905) 457-6223. -
Page 4: Maintenance
REPAIR PRIMING The pump casing and suction pipe must be com pletely fi lled with liquid before operating the pump. WARNING If Pumping Any Fluid That Could Cause Bodily Injury (Hot water, caustic, etc.), Always Use Eye Pump priming may be accomplished by one of the Protection and Wear Protective Clothing Over All following methods. - Page 5 LOCATING TROUBLE 2. REASSEMBLY (Continued) 1. No Water Delivered. a. Pump not primed e. Slide key (032) impeller (002) and fasten with b. Speed too low. Check with revolution counter. washer, and capscrew (026). c. Discharge head too high. d. Suction lift over 15 feet. Check with vacuum f.
- Page 6 ITEM No. DESCRITION ITEM No. DESCRITION Casing *089 Seal, Mechanical Impeller Nameplate Ring, Impeller (Optional) Plug, Pipe Sleeve, Shaft Cap screw Ring, Casing Screw, Drive *026 Cap screw Plug, Pipe *030 Gasket, Impeller Cap screw Key, Impeller *270 Washer, Impeller *038 Gasket, Sleeve *272...
- Page 7 ITEM No. DESCRITION ITEM No. DESCRITION Casing *089 Seal, Mechanical Impeller Nameplate Ring, Impeller (Optional) Plug, Pipe Sleeve, Shaft Cap screw Ring, Casing Screw, Drive *026 Cap screw Plug, Pipe *030 Gasket, Impeller Cap screw Key, Impeller *270 Washer, Impeller *038 Gasket, Sleeve *272...
- Page 8 Limited 24 Month Warranty Crane Pumps & Systems warrants that products of our manufacture will be free of defects in material and workmanship under normal use and service for twenty-four (24) months after manufacture date, when installed and maintained in accordance with our instructions.This warranty gives you specifi c legal rights, and there may also be other rights which vary from state to state.
- Page 9 Crane Pumps & Systems, Inc. Distributor. RETURNED GOODS RETURN OF MERCHANDISE REQUIRES A “RETURNED GOODS AUTHORIZATION”. CONTACT YOUR LOCAL CRANE PUMPS & SYSTEMS, INC. DISTRIBUTOR. Products Returned Must Be Cleaned, Sanitized, Or Decontaminated As Necessary Prior To Shipment, To Insure That Employees Will Not Be Exposed To Health Hazards In Handling Said Material.
- Page 10 Notes...
Need help?
Do you have a question about the WEINMAN Sections 150 and is the answer not in the manual?
Questions and answers