Flex FX7141A Operator's Manual page 30

e. Long pieces need extra support. The base
height [3-1/2" (90mm)] is designed to match
the standard lumber of one 4x (89mm).
Boards of this thicknesses can be used to
create auxiliary support extensions for long
workpieces (Fig. 26d).
WARNING
able to properly support the workpiece and
allow for secure holding by hand outside of
the "No Hand Zone", or clamping with a
clamp inside or outside of the "No Hand
Zone".
WARNING
workpiece. Unsupported workpiece can move
out of position during cut and cause injury and/
or tool damage (Fig. 26e).
TO MAKE AN AUXILIARY FENCE (FIG. 27)
Depending on the size and position of
the workpiece, certain unusual cuts may
benefit from the additional support that
can be provided by an auxiliary fence. The
holes provided in the sliding fence are used
to secure an auxiliary fence in place.
WARNING
bevel is set at 0°. When making a bevel cut,
auxiliary fence MUST be removed.
Always ensure that
supporting surfaces are
Always adjust the sliding
base extension to support
The auxiliary fence can
only be used when the
Fig. 26c
2
Fig. 26d
Add one
4x
Fig. 26e
X
Fig. 27
Auxiliary
Fence
-30-
1
√
Align of Miter Table