Flex FX7141A Operator's Manual page 26

The mitre saw can be used for sawing wood or
materials similar to wood, plastics, aluminum
and round or irregularly shaped material.
WARNING
product damage due to a short circuit, never
immerse your charger or battery pack in fluid
or allow a fluid to flow inside them. Corrosive
or conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach-
containing products, etc. can cause a short
circuit.
MAIN SWITCH (FIG. 21)
The main switch has a lock-off lever that must
be moved to the left to be able to depress the
main switch. Grasp the main switch with your
fingers and move the lock-off lever to the left.
Then pull the main switch to activate the saw.
Release the main switch to stop the saw.
This miter saw must be used only with the
battery packs and chargers listed below:
2.5Ah 3.5Ah 5.0Ah
FX0111 FX0321 FX0121
NOTE: Please refer to the battery pack and charger manuals for detailed operating information.
LED SHADOW LIGHT (FIG. 22)
WARNING
distance). Staring into the light beam may
result in serious injury or vision loss.
The LED shadow light system is controlled by
the shadow light switch and is independent
from the miter saw main switch.
If the shadow light is turned on only by pressing
the shadow light switch without activating the
main switch, light will be on for 1 minute, then
turn off automatically.
To cut through an existing pencil line on a piece
of wood, turn on the shadow light system, then
pull down on the operating handle to bring the
saw blade close to the wood. The shadow of
the blade will appear on the wood.
OPERATING INSTRUCTIONS
To reduce the risk of fire,
personal injury, and
Battery Pack
6Ah 8.0Ah
FX0331 FX0221
Do not stare into the light
beam (not even from a
WARNING
this product until the parts are replaced. Use
of this product with damaged or missing parts
could result in serious personal injury.
WARNING
serious personal injury, always remove the
battery pack from the tool when assembling
or adjusting parts.
Fig. 21
10Ah 12Ah
FX0341 FX0231 FLEX
FX0411
Fig. 22
This shadow line represents the material that
the blade will remove when performing a cut.
-26-
If any parts are damaged
or missing, do not operate
To prevent accidental
starting that could cause
1
2
Main Switch
Charger
FLEX FLEX
FX0421 FX0431
Shadow
Light
Switch
Lock-off
Lever
FLEX
FX0451