Transmitter Programming - CrimeStopper RS800 Installation Instructions Manual

Remote engine starting system

Hide thumbs Also See for RS800:

Installation instructions manual (13 pages)

Operating instructions (4 pages)

Operating instructions (4 pages)

Table Of Contents

Table of Contents

TACH (RPM) REFERENCE MODE / TACH FINDER MODE / TACH PROGRAMMING

NOTE (1): The Tach Signal locations on page 9 are provided as a guide, your vehicle may differ. Some locations

will NOT be a good location for Tach source due to RF noise or Computer Data. The RS-900 may not detect a

clean signal. Of you are unable to locate a Tach Source, call Crimestopper for Tech Support: (800) 998-6880.

NOTE (2) The RS900 will operate in "Smart Tachless" Mode [by default] unless a Tach Reference has been

programmed. This unit automatically switch out of "Smart Tachless" Mode when Tach is programmed.

Transmitter Code Learning:

Note: All transmitter codes must be learned at time of programming!! The RS800 allows storage of up to 4

different transmitter codes.

1. Open Hood. (Ground Gray wire.)

2. Turn key to the ON position.

3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.

4. Press button #1 of the transmitter to be coded. You should get 2 light flashes indication the unit is waiting for a 2

code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting for the 3

lights will flash 4 times for 4

otherwise turn key OFF and close hood. (See diagram below)