Emerson IC695PNS001-BHBF1 2 Important Product Information page 11

GFK-2738AE
Installing the PNS in an RX3i Backplane
1. The Scanner can be installed in slot 1 or 2 of a 7, 12,
or 16-slot RX3i Universal Backplane, or slot 6 of a 7-
slot RX3i Universal Backplane. The installation slot
must match the slot that is selected in the module's
hardware configuration.
2. RX3i rack power must be turned off. The PNS does
not support insertion/removal while power is applied
to the system (hot-swap).
3. Holding the module firmly, align the module with the
correct slot and connector.
4. Engage the module's rear pivot hook in the notch on
the top of the backplane (Arrow 1, Error! Reference s
ource not found.).
5. Swing the module down (Arrow 2, Error! Reference s
ource not found.) until the module's connector
engages the backplane's backplane connector.
6. Visually inspect the module to be sure it is properly
seated.
7. Secure the bottom of the module to the backplane
using the machine screws provided with the module
(Arrow 3, Error! Reference source not found.).
Figure 2: Installing the PNS Module into a
Backplane
Jan 2024
8