Dometic FreshWell FWX4350EHP Installation And Operating Manual page 16

EN
Under no circumstances shall potential sources of ignition be used
•
in the searching for or detection of refrigerant leaks. A halide torch
(or any other detector using a naked flame) shall not be used.
• Do not use means to accelerate the defrosting process or to clean, other than those recommended
by the manufacturer.
• Do not pierce or burn the appliance.
• Be aware that refrigerants may not contain an odor.
WARNING! Risk of injury
• Do not operate the device if it is visibly damaged.
This device can be used by children aged from 8 years and above
•
and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given su-
pervision or instruction concerning use of the device in a safe way
and understand the hazards involved.
• Electrical devices are not toys. Always keep and use the device out of the reach of very young
children or infirm persons.
Children shall not play with the device.
•
Cleaning and user maintenance shall not be made by children
•
without supervision.
• Do not make any alterations or conversions to the device.
• Do not reach into air outlets or insert any foreign objects in the underbench air conditioner.
• Do not open or damage the refrigerant circuit under any circumstances.
• Maintenance shall only be performed as recommended by the equipment manufacturer. Mainte-
nance and repair requiring the assistance of other qualified personnel shall be carried out under the
supervision of the person competent in the use of flammable refrigerants.
NOTICE! Damage hazard
• If faults occur in the device's refrigerant circuit, the device must be checked by a specialist company
and properly repaired. The refrigerant must never be released into the air.
• Do not apply heavy objects or pressure on the device.
• Do not expose the under-bench air conditioner to water.
Installing the device safetly
WARNING! Risk of injury
• The device must be installed securely so that it cannot fall down.
• Attach and lay the cables so that they cannot be tripped over or damaged.
NOTICE! Damage hazard
• Ensure that the voltage specification on the data plate is the same as the voltage specification of the
power supply.
• Use cable ducts to lay cables through walls with sharp edges.
14