Panasonic WJ-FS216 Operating Instructions Manual page 26

* Remote Control
You can contro! the SEQUENCE, MULTISCREEN/QUAD SHIFT functions, and the camera selection buttons from a
remote controller. These functions are activated by contact with the ground terminal (open collector output or normally
open Contact).
* Connect the SEQUENCE connector (pin 19) to the ground terminal as shown below. Buttons 1 - 16 select the cameras
(they do not control the alarm input).
Notes:
e Any two or more switches closed at the same time will cause this unit to malfunction.
e SEQUENCE is assigned to switch 17 and MULTISCREEN/QUAD SHIFT to switch 18.
* When no operation is taking place, all switches except switch 19 must be open as shown below.
D-SUB CONNECTOR
(MALE)
O,O,O,O,O1,0,0\0
16 415 \14 \13 M2 \11 \10 \9
5 z W a
£ wer 2 ] z
ó wl á CH Selection a
O52 Č
an. oO oO
Eu
rain
22
zo
-24-