Panasonic WJ-FS216 Operating Instructions Manual page 10

2.
2.
ALARM BUZZER
The buzzer beeps when this unit receives the alarm
signal. You can adjust the buzzer time between 1
and 60 seconds by changing the ALARM BUZZER
parameter.
. Move the cursor to the ALARM BUZZER parameter.
. Select the buzzer time.
OFF: The alarm buzzer does not beep when the
alarm signal is received.
1-30, 60S: The buzzer keeps on beeping for the
duration you set. The letter "S" stands for sec-
onds.
The factory setting is 28.
* MENU1 OF 3 *
DYNAMIC REC OFF
ALARM BUZZER 28
ALARM OUTPUT 28
REC MODE 4FIELDS
PLAYBACK MODE FIELD
ALARM OUTPUT
When alarm is received, the alarm signal is sup-
plied to the other device through the
ALARM/REMOTE connector. You can adjust the
duration the alarm signal is output between 1 and
60 seconds.
* MENU1 OF 3 *
DYNAMIC REC OFF
ALARM BUZZER 2s
ALARM OUTPUT 28
REC MODE 4FIELDS
PLAYBACK MODE FIELD
Select the duration the alarm signal is output.
1-30, 60S: The alarm signal is output for the dura-
tion you set. The letter "S" stands for seconds.
The factory setting is 2S.
4. REC MODE
The recording mode can be set to 4-90 fields or
time lapse recording.
. Move the cursor to the REC MODE parameter.
* MENU1 OF 3 *
DYNAMIC REC OFF
ALARM BUZZER 2s
ALARM OUTPUT 2s
AFIELDS
REC MODE
PLAYBACK MODE FIELD
. Select the recording mode.
4-90 FIELDS: The output signal to be recorded on
the VCR is switched every fields you have set.
T/L: The recording output signal is supplied to the
VCR for time lapse recording.
The factory setting is 4 FIELDS.
Note:
When T/L is selected and no camera switching
signal supplied, there will be no correct time
lapse recording. In this case, either supply the
camera switching signal or select 4 - 90 fields
in REC mode for normal recording.
PLAYBACK MODE
This unit can play back tape recorded by WJ-FS20
or WJ-FS10.
. Move the cursor to the PLAYBACK MODE parame-
ter.
* MENU1 OF 3 *
DYNAMIC REC OFF
ALARM BUZZER 28
ALARM OUTPUT 28
REC MODE 4FIELDS
PLAYBACK MODE FIELD
. Select the tape type.
FIELD: To replay tapes recorded on this unit or the
WJ-FS20.
FS10: To replay tapes recorded on the WJ-FS10.
The factory setting is FIELD.
Notes:
* The WJ-FS10 cannot play back tapes recorded
on the WJ-FS216.
e When playing back a tape recorded on the WJ-
FS10, note that the channel number for record-
ing and playback is different. Display the 4x4
screen to check the channel number and select
the desired picture.