Panasonic WJ-FS216 Operating Instructions Manual page 13

3. SEQUENCE SETUP
This parameter lets you set the sequential order and
dwell time for camera switching.
. Move the cursor to SEQUENCE SETUP.
4. START SCREEN
This parameter iets you select a display pattern for
your startup screen. When the power is turned on,
the picture is displayed in the selected pattern.
1. Move the cursor to the START SCREEN parameter.
* MENU3 OF 3 *
* MENU3 OF 3 *
BORDER WHITE
AUTO SKIP OFF
BORDER WHITE
AUTO SKIP
START SCREEN l-SEQ
SEQUENCE SETUP *
SYSTEM MODE MULTIPLEX
START SCREEN 1-SEQ.
SYSTEM MODE MULTIPLEX
2. Press button 15 (SET). The SEQUENCE menu
appears on the monitor. 2. Select FULL or 1-SEQ.
FULL: A single picture is displayed.
1-SEQ: A sequence of a single picture is displayed.
Sequence Number Channel Dwell Time The factory setting is 1-SEQ.
S VT
Wit
9CH 28
10CR 2S
11CH 28
12CH 2S
SYSTEM MODE
See "Selecting the system mode" on page 6 for set-
tings and procedures.
1-1CH -25
2CH 2S
3CH 28
4CH 2S
13CH 28
l4CH 28
15CH 2S
16CH 2S
5CH 28
6CH 2S
7CH 2S
8CH 2S
3. Move the cursor to the sequence number by press-
ing buttons 9-12 (A, V. <, D»).
4. Select the channel by pressing button 13 (-) or 14
(+).
9. Move the cursor to the dwell time by pressing but-
ton 12 (©).
6. Select desired dwell time by pressing button 13 (-)
or 14 (+).
lf you select OFF for the dwell time, the selected
channel is automatically skipped.
7. Repeat steps 3 to 6 to determine the sequential
order and dwell time.
8. Press button 15 (SET) to finalize the sequential
order. The display returns to MENU 3 OF 3.
Note: When monitoring a quad picture, the dwelt time
indicated for sequence numbers 1-4 refers to that of
the four quad pictures.
udis