Panasonic WJ-FS216 Operating Instructions Manual page 21

MULTISCR Mode
Select this mode to monitor the camera pictures.
Selection of MULTISCR mode permits the following
operations.
Monitoring the camera picture
A. Single Spot Picture
Proceed as described in "Monitoring the Camera Picture,
A. Single Spot Picture" on page 14.
B. Multi Spot Picture
. Set the MODE SELECT/CAMERA SELECT switch to
CAMERA SELECT.
2. Press the ZOOM/MULTISCREEN/QUAD SHIFT but-
ton. The multiscreen appears on the monitor.
3. Set the MODE SELECT/CAMERA SELECT switch to
MODE SELECT.
4. Press button 1 (EB) 2(&B). or 3 (GB
multiscreen pattern (quad, 3x3, or 4x4).
-—
) to select
Notes:
* Every divided picture is displayed by frame
skipping.
* Multi spot pictures being monitored may vibrate
vertically sometimes, but this does not indicate
a matfunction.
* Quad shift is available by pressing the
ZOOM/MULTISCREEN/QUAD SHIFT button.
Refer to page 16 for more details.
C. Single Spot or Quad Picture Sequences
You can monitor sequential spot pictures or quad
pictures. First select a display pattern.
To monitor sequential single spot pictures, take the
same steps as described in the procedures B for
the "Single Spot Picture Sequences of Monitoring
Camera Pictures" on page 14.
To monitor sequential quad pictures, proceed as
described in the following procedures.
1. Take the steps 1 to 3 of Procedures B for Multi Spot
Pictures.
2. Press the ( EB) button 1 to select quad pictures.
3. Press the SEQUENCE/ALARM RESET button. The
quad pictures appear sequentially in the order of
dwell times set on the SEQUENCE SETUP in MENU
3 OF 3.
Example of quad picture sequence
Camera 1 Camera 2
Picture Picture
Camera 5 Camera 6
Picture Picture
Camera 8 Camera 10
Picture - Picture
Camera 12 Camera 16
Picture Picture
4. To cancel sequential picture display, press the
desired camera selection button. The selected
camera picture appears on the single picture
screen of the monitor.
-19-