Panasonic WJ-FS216 Operating Instructions Manual page 22

D. Still Multi Spot Picture
The fotlowing function is available in multi spot
picture mode only.
i,
e
Set the MODE SELECT/CAMERA SELECT switch to
MODE SELECT.
Press the (STILL ON) button 16. The STILL ON indi-
cator lights.
. Set the MODE SELECT/CAMERA SELECT to CAM-
ERA SELECT.
. Press one of the camera selection buttons whose
indicator is lit.
The LED on the pressed button starts blinking and
the picture corresponding to that button appears
still on the monitor.
The word STILL appears blinking on the monitor
screen.
. Press the camera selection button whose indicator
is blinking.
The selected picture is displayed again for normal
monitoring.
. To release STILL mode, set the MODE SELECT/
CAMERA SELECT switch to MODE SELECT, then
press the (STILL ON) button 16.
The STILL ON indicator goes out.
"mH
3 ENTRANCE
Normai Camera Picture
Still Picture
(The word "STILL" blinks)
Notes:
e |f you press the camera selection button for a
camera whose picture is not displayed on the
monitor screen, the operation is ignored.
* The word "STILL" is not displayed if STILL/
ALARM DISP in MENU 2 OF 3 is set to OFF.
-20-
E. Zoomed Multi Spot Picture
The following function is available in multi spot
picture mode only.
1.
2.
Set the MODE SELECT/CAMERA SELECT switch to
MODE SELECT.
Press the ZOOM/MULTISCREEN/QUAD button. The
"+" sign appears in the picture.
Note: The "+" sign disappears if no operation takes
place within approx. 5 seconds.
. Move the "+" sign to the picture you want to zoom by
pressing buttons 9-12 (A, V, «1 >).
. Press button 14 (+) to zoom in. To zoom out, press
button 13 (-).
Notes:
* Each time you press the 14 (+) button, the pic-
ture is zoomed in. The zooming stops at the
maximum.
* You cannot reduce the picture to less than its
original size by zooming out with button 13 (-).
Press the 9-12 (A, V, «1, E») buttons. The zoomed
picture moves in the direction of the button you
pressed.
It stops at the edge of the monitor screen.
3ENTRANCE
Normal Camera Picture
23
Picture with the "+" sign
Zoomed Picture
Notes:
* When you change the multiscreen pattern (for
example, quad to 3x3), the size of the zoomed pic-
ture is not the same even if the picture is from the
same channel.
The title in the picture disappears when the
ZOOM/MULTISCREEN/QUAD button is pressed.
The title remains out even after the "+" sign dis-
appears.
To call the title back on the screen, quit the zoom
function and operate another function.