Panasonic WJ-FS216 Operating Instructions Manual page 14

2. Press button 15 (SET). The CH SET menu appears
on the monitor.
A. Setting up MENU 1 OF 3 in the
MULTISCREEN mode
. AUTO RESET
This parameter lets you set the time until the unit
recovers after receiving the alarm signal.
. Move the cursor to the AUTO RESET parameter.
t MENU1 OF 3 *
AUTO RESET
ALARM BUZZER
ALARM OUTPUT
MULTISCR CH SET *
. Select the recover time.
OFF: The alarm condition is maintained until the
ALARM RESET button on the front panel is
pressed or the alarm recover signal from the
time lapse VCR is supplied to the
ALARM/REMOTE connector.
1-30, 60S: The alarm condition is maintained for the
length of the recover time you set. The letter
"S" stands for seconds.
The factory setting is 60S.
. ALARM BUZZER
This item is the same as in MENU 1 OF 3 in the
MULTIPLEX mode. See page 8 for the settings and
procedures.
. ALARM OUTPUT
This item is the same as in MENU 1 OF 3 in the
MULTIPLEX mode. See page 8 for the settings and
procedures.
. MULTISCR CH SET
This parameter lets you assign the channel to be
displayed to a specific divided screen.
1. Move the cursor to CH SET in MULTISCR CH
SET.
* MENU1 OF 3 *
AUTO RESET 60S
ALARM BUZZER - : 28
ALARM OUTPUT 28
MULTISCR |(CH/JSET:*
3. Press button 1 or 2 to select the CH SET menu for
MULTISCREEN.
Button 1: Displays the CH SET menu for quad and
4x4 multiscreen.
Button 2: Displays the CH SET menu for 3x3 multi-
screen.
** CH SET **
sles
1-1CH-
2CH
3CH
4CH
5CH
6CH
7CH
8CH
. Move the cursor to the number of the divided
screen by pressing buttons 9-12 (A, V, <, D»).
. Select the channel number to be assigned to the
selected divided screen by pressing button 13 (-)
or 14 (+).
. Repeat steps 4 and 5 above to assign the other
channels to the divided screens.
. Press button 15 (SET) to finalize channel assign-
ment. The display returns to MENU 1 OF 3.