Panasonic WJ-FS216 Operating Instructions Manual page 20

Note: Two or more pictures on the monitor can be
selected in multi picture mode.
. Press the camera selection button whose indicator
is blinking.
The selected picture is displayed again for normal
monitoring.
. To release STILL ON mode, set the MODE
SELECT/CAMERA SELECT switch to MODE
SELECT, then press the button 16 (STILL ON).
The STILL ON indicator goes out.
Notes:
* |f you press the camera selection button for a cam-
era whose picture is not displayed on the monitor
screen, the operation is ignored.
The word "STILL" is not displayed if STILL/ALARM
DISP in MENU 2 OF 3 is set to OFF.
While the still picture is displayed, the VCR keeps
playing the playback picture.
. Single Spot Picture Zoom
The following function is available in single spot
picture mode only.
. Repeat the procedures A (Single Spot Picture) to
monitor the playback picture.
. Set the MODE SELECT/CAMERA SELECT switch to
CAMERA SELECT.
. Press the ZOOM/MULTISCREEN/QUAD button.
The "+" sign appears in the picture.
Note: The "+" sign disappears if no operation is
performed for 5 seconds or longer.
. Press the (+) button 14 to zoom in, or the (-) button
13 to zoom out.
Notes:
* Each time the (+) button 14 is pressed, the pic-
ture is zoomed in. The zoom stops when it
reaches the maximum level.
e The picture cannot be zoomed out to be small-
er than the original size by pressing the (-) but-
ton 13.
. Press the (A, V, «3, E») button 9, 10, 11, or 12.
The zoomed picture moves in the direction of the
pressed button.
The picture stops at the end of the monitor screen.
-18-
Playback Zoomed Picture
Notes:
e |n monitoring single spot playback pictures, only
one zoom tevel is available.
+ The title in the picture disappears when the
ZOOM/MULTISCREEN/QUAD button is pressed.
The title remains out even after the "+" sign dis-
appears.
To call the title back on the screen, quit the zoom
function and operate another function.