Panasonic WJ-FS216 Operating Instructions Manual page 16

OPERATION
Before starting the operation, set up the items of
MENU 1-3 OF 3.
Set SYSTEM MODE in MENU 3 OF 3 to MULTIPLEX or
MULTISCR depending on your specific needs.
MULTIPLEX Mode
Select this mode to monitor camera pictures or play-
back pictures.
The operations enabled in MULTIPLEX mode are
described below.
E Monitoring the Camera Picture
Caution: Set the time lapse VCR to the stop mode or
recording mode.
1. Set the MODE SELECT/CAMERA SELECT switch to
MODE SELECT.
Esp
2. Press button 8 (CAMERA/VCR). The CAMERA /
VCR indicator goes off.
CAMERANVCR XX
folk
3. Press button 16 (STILL ON). The STILL ON indicator
goes off.
g i
STLLON i
-14-
. Single Spot Picture
. Set the MODE SELECT/CAMERA SELECT switch to
CAMERA SELECT.
. Press one of the camera selection buttons for dis-
play on the monitor.
The LED on the selected button lights and the
selected camera picture appears on the monitor.
3 ENTRANCE
Camera Picture
. Single Spot Picture Sequences
. Select the MODE SELECT / CAMERA SELECT
switch to CAMERA SELECT.
. Press the SEQUENCE / ALARM RESET button.
A sequence of a single pictures is displayed in the
order and switching time selected for the
SEQUENCE SETUP parameter in MENU 3 OF 3.
Example of single spot picture sequence
Camera 3 Picture
Camera 6 Picture
. To cancel the sequence, press the desired camera
selection button.
The selected camera picture appears in spot on the
monitor.