Table of Contents
Advertisement
Echoflex Installation Guide
Ceiling & High Bay Occupancy Sensor
PIR sensing must have an unobstructed view of the space. Do not
•
mount behind or near tall cabinets, shelves, or hanging light fixtures.
Avoid locating the sensor where it can easily sense movement
•
outside of the intended space, such as hallways, glass partitions, or
adjacent rooms. If these conditions are unavoidable, use lens mask
stickers to block off specific areas. See
Do not install within 2.5 m (8 ft) of an HVAC airflow duct or vent.
•
Supplies required to install (not provided):
Two #6 screws, double-sided tape, or Velcro
•
Installation
The sensor can be attached to a suspended ceiling or finished wallboard
ceiling. An auxiliary mounting plate with integrated magnets is also
provided. Determine the installation method and follow the instructions.
Note:
before replacing the cover. See
Wire Staples to Ceiling Tile
1. Remove the sensor cover to access the mounting pinholes.
2. Mark the sensor mounting location on the ceiling tile.
3. Remove the ceiling tile from the T-bar frame.
4. Insert the wire staples (provided) through the pinholes on the sensor,
one set located on each side near the keyholes.
5. Poke the tines through the ceiling tile, then bend each tine over in
opposite directions for a secure fit.
6. Replace the ceiling tile and reattach the sensor cover.
Wallboard Ceiling
1. Remove the sensor cover to access the mounting keyholes.
2. Mark the location of the keyholes on the ceiling.
3. Bore two holes and insert screw anchors (not provided).
4. Attach the sensor to the ceiling with screws (not provided).
5. Replace the sensor cover.
Integrated Magnets
Attach sensor directly to the suspended ceiling T-bar frame using the
auxiliary mounting plate's integrated magnets.
Adhesive
Use double-sided tape or Velcro (not provided). Cut a piece of double-
sided adhesive tape or adhesive-backed Velcro to the appropriate length
and press firmly in place.
Ceiling & High Bay Occupancy Sensor
Consider linking the MOS while you have access and
Lens Masking on
®
Link to a Controller on
Page 2 of 12
page 4.
page 4.
Echoflex
Advertisement
Table of Contents
