Table of Contents
Advertisement
Echoflex Installation Guide
Ceiling & High Bay Occupancy Sensor
Battery Power
A battery is not required for normal operation of A and B lens models if
the sensor receives adequate natural or artificial light. See the table in the
Light Level Test
to run installation tests or when the artificial light is insufficient to power
the sensor.
A CR2032 is included with the MOS IR*C lens model. The battery may be
factory installed or packed separately according to shipping regulations.
Insert the battery if required or remove the protective plastic tab before
installing the MOS.
1. Insert a precision flatblade screwdriver under the clear plastic cover at
one of the release tabs in the base plate and pull up. Repeat with at
least two tabs until the cover pops free.
2. Use your finger to remove the old battery from the holder. Insert a
new battery with the + positive side facing up and press in place.
3. Replace the cover over the sensor aligning the button hole with the
[Teach] button and press in place.
Tests and Settings
Use the [Teach] button and color LEDs to navigate the Tests and Settings
menu. The [Teach] button is on the front of the sensor and the LEDs show
through the lens.
Light Level Test
•
Range Confirmation
•
Walk Test
•
Sensor Setting
•
LED Display
•
The menu times out after two minutes of inactivity. An LED sequence
flashes to confirm when you enter the menu or if you exit before it times
out.
Light Level Test
The Light Level Test quantifies the amount of energy produced by the
solar cells and confirms a good installation location.
1. Press and hold the [Teach] button until the green LED is displayed.
Release the button to enter the menu and display the first item, the
blinking green LED.
Ceiling & High Bay Occupancy Sensor
below. A CR2032 battery (not provided) may be required
(green LED)
(blue LED)
(red LED)
(red and blue LEDs)
(green and red LEDs)
Page 5 of 12
Echoflex
Advertisement
Table of Contents
