Table of Contents
Advertisement
Echoflex Installation Guide
Ceiling & High Bay Occupancy Sensor
6. Press the [Teach] button to cycle through the settings.
Blinks
1
2
3
4
5
6
7. Press and hold the [Teach] button for 10 seconds to save and exit.
Note:
active the full duration of the Audio Enabled Timer. Disabling both
the Occupancy Timer and Audio Sensitivity sets the sensor to
detect PIR only.
LED Display
The LED Display setting enables or disables the LEDs. Blinking LEDs are
informative but not suitable for every location. Disabling the LEDs
eliminates distractions as well as conserves battery power. If disabled, the
LEDs still operate to run tests and indicate low battery.
1. Press and hold the [Teach] button until the green LED is displayed.
Release the button to enter the menu and display the first item, the
blinking green LED.
2. Press and release the [Teach] button to cycle the menu of color LEDs
and stop when the green and red LEDs are both blinking.
3. Press and hold the [Teach] button until the LEDs stop blinking to
select LED Display.
4. Press the [Teach] button to toggle between the two states:
Red LED blinking - enable LEDs for motion detection
•
Green LED blinking - disable LEDs for motion detection
•
5. Press and hold the [Teach] button for five seconds to save and exit.
Ceiling & High Bay Occupancy Sensor
PIR Sensitivity
Green LED
High (default)
Medium
Low
If the Occupancy Timer is disabled, the audio remains
Audio Sensitivity
Blue LED
Automatic (default)
Low
Disabled
Page 8 of 12
Occupancy Timer
Red LED
Disabled
5 mins
10 mins
15 mins
20 mins (default)
25 mins
Echoflex
Advertisement
Table of Contents
