Daikin AAF AstroPure 500 IR Installation, Operation And Maintenance Manual page 26

CONTROL PANEL (CONT'D)
Screen
Note: The Decontamination Cycle is intended to provide fast recovery and/or reduce the room contamination is short order by operating the unit
at a higher airflow (fan speed). Operating in this manner (i.e. at a high fan speed) will increase the noise level of the unit, so it is recommended
to run the decontamination cycle either prior to occupancy of the room or during times of no/minimal occupancy. The Decontamination Cycle
period is intended to function as a part of the Autonomous Operation Scheduled (see section:s "Adjust Room Decontamination cycle (Period
and fan speed)" and runs automatically when the unit is set-up for operating according to the user pre-defined schedule. However, it may be
necessary to run a decontamination cycle due to a high contamination event, even if the Autonomous Operation Scheduling function is not
activated. In this case, it is recommended to run a decontamination cycle manually.
26
OPERATIONS MODE – FUNCTIONALITY
Button
Setting Autonomous Operation Schedule
On the "Room Decontamination", press (5) Return to move
the "Schedule programming". Press and hold for 5 secs
(3) Enter button, and the eld will start blinking use the
(4) Up or (6) (Down) buttons to select the number desired
and (3) Enter button to move on the eld (day, start and stop)
To copy the same settings from the previous day, press
(2) Function plus (6) Down the previous day's settings will
automatically populate.
Note: For days when the unit shall not run, adjust the initial
and final hour with identical values.
Activating autonomous (scheduled) operation
On the "Main screen", press (2) Function plus (1) On/Off.
The icon "clock" will appear when activated. To deactivate
this function, repeat the procedure. When activated, is
possible to navigate between screens, however, the unit
can not be turned on/off.
Note: For days when the unit shall not run, adjust the initial
and final hour with identical values.
Manual Decontamination Cycle
The decontamination cycle can be activated manually. To
turn on this function press (2) Function plus (4) Up from the
main screen. A countdown timer will display on the main
screen. At the end of this period, the unit will return to the
previous operation status and fan speed set point. To cancel
a manual Decontamination cycle, repeat the procedure that
will disable the function.
To activate or deactivate the display lock function
From the main screen, press the (2) Function button plus
the (3) Return button. The Lock icon will indicate whether
the display is currently locked or unlocked. When the
display is locked, all buttons, including the on/off button,
will be inoperable. To unlock the display, repeat the same
processand observe the lock icon.
Action