Waldorf IRIDIUM CORE Quick Start Manual page 10

Fast Setup and Connections
6. Connect the power supply cable or the power
cable that came with your Iridium Core with the
Power supply jack. Plug the other side of the
power supply cable into a suitable AC power out-
let.
7. Press the power switch on the rear panel of your
Iridium Core.
8. Then switch on your computer (if connected), the
mixing console and finally the amplifier or active
monitor speakers.
r
The startup procedure is about 10-15 seconds. After
this, the Iridium Core is ready to play.
r
The overall volume of the Iridium Core can be con-
trolled with the Volume dial below the touchscreen.
This also affects the Headphones output (when the
Pot Mode is set to Default)
r
If you do not choose to connect a mixing console,
you can patch the Iridium Core's output signals di-
rectly to an amplifier or an audio interface. Use an
input usually called Line, Aux or Tape input.
s
Before connecting and disconnecting the Iridium
Core to a power supply source, turn your amp's vo-
lume control all the way down to avoid damage due
to on/off switching noise. The Iridium Core produces
a high level output signal. Please take care that the
connected playback device is suitable for the high le-
vel of an electronic instrument. Never use the micro-
phone or phono input of the connected amp!
10 Iridium Core Quickstart