Handlebar Switches - Yamaha TRACER MTT9K 2019 Owner's Manual

Instrument and control functions

Handlebar switches

Left
2 1
3
4
4
5
1. Select switch " /
2. Menu switch "MENU"
3. Dimmer/Pass switch "
4. Turn signal switch " /
5. Horn switch " "
Right
EAU1234M
1. Stop/Run/Start switch "
2. Drive mode switch "MODE"
3. Hazard switch "
"
/ /PASS"
Dimmer/Pass switch "
"
Set this switch to "
beam and to "
To flash the high beam, push the pass
side "PASS" of the switch while the
headlights are on low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
1
2
3
/ / "
"
EAU54201
/ /PASS"
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When
4-16
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
set this switch to " ", and then push
the switch down towards "
page 6-1 for starting instructions prior
to starting the engine.
Set this switch to " " to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
EAU12501
EAU54212
/ / "
". See
EAU12735
" posi-