Yamaha TRACER MTT9K 2019 Owner's Manual page 26

Instrument and control functions
button briefly so that the tripmeter
flashes, and then push the "RESET"
button again for two seconds.
TIP
 The odometer will lock at 999999.
 The tripmeters will reset and con-
tinue counting after 9999.9 is
reached.
4
Fuel reserve tripmeter
When approximately 2.6 L (0.69 US
gal, 0.57 Imp.gal) of fuel remains in the
fuel tank, the last segment of the fuel
meter starts flashing. The display will
change to the fuel reserve tripmeter
mode "TRIP-F" and start counting the
distance traveled from that point.
GEAR
4
TRIP-F
In this case, push the select switch to
switch the display in the following or-
der:
TRIP-F → Display–1 → Display–2 →
Display–3 → TRIP-F
After refueling, you can manually reset
the fuel reserve tripmeter immediately,
or allow it to reset automatically after
traveling 5 km (3 mi). When the fuel re-
serve tripmeter is reset, it will disap-
pear from the display.
Elapsed time
This timer shows the time that has
elapsed since the key was turned to
"ON". The timer automatically resets
when the key is turned to "OFF".
mile
2.1
TIME TRIP
0:06
4-8
TIP
There are also "TIME–2" and "TIME–3"
elapsed time displays, but they cannot
be set to the information display. See
Setting mode on page 4-10 for more
information.
Air temperature
A.TEMP
77
This shows the air temperature from 16
°F to 199 °F in 1 °F increments. The
temperature displayed may vary from
the ambient temperature.
TIP
 16 °F will be displayed even if the
ambient temperature falls below
16 °F.
 The accuracy of the temperature
reading may be affected when rid-
ing slowly (under 20 km/h [13
mi/h]) or when stopped at traffic
signals, railroad crossings, etc.
˚F