Safety Label Definitions - Wallenstein BXT72S Operator's Manual

Safety Labels

3.3 Safety Label Definitions

1. Warning!
Cut hazard
Sharp rotating parts can cut or sever
fingers, hands, toes, or feet.
Keep hands and feet out of the chipper
hopper or discharge chute when the
machine is on and not in a safe condition.
2. Warning!
Machine damage and possible
entanglement hazard
Oversize material will overload the
machine, which can stall the engine or
cause machine damage. If you try to
force material into the machine, it can
result in serious injury from a fall or
entanglement. Carefully remove oversize
material from the machine.
Do not put material that is larger than
7" (18 cm) in diameter into the chipper
hopper. Do not try to force material into
the machine.
3. Caution!
Wear the necessary PPE
For example:
• A hard hat.
• Heavy gloves.
• Hearing protection.
• Protective footwear with steel toes
and slip resistant soles.
• Protective goggles or a face shield
4. Warning!
Entanglement, pinch, and crush hazards
Rotating parts can pull in, pinch, and
crush fingers and hands. Install the guard
when work is complete.
Keep your hands away from the drive
belt. Turn off the machine and put it
in a safe condition before service or
maintenance. Wear heavy gloves and use
caution when working in this area.
5. Warning!
Entanglement, pinch, and crush hazards
Keep hands away from this area. Do not
put your hands inside the guard.
Do not operate the machine with a guard
removed. Make sure that all of the guards
and shields are installed and the covers
are closed before you start the machine.
Rotating parts that can entangle, pinch,
or crush fingers and hands are exposed
when the guard is removed.
16
BXT72S
Wood Chipper