Table of Contents
Advertisement
6. Remove the three screws (B3 x 5) to detach
the lift lock shoe (F).
7. Loosen the three setscrews.
8. Remove the two screws (K3 x 6) of the arm
(R) sub assembly.
9. Remove the four screws (P3 x 5) of the arm
(R) sub assembly.
10. Remove the arm (R) sub assembly from the
shaft of the VF holder sub assembly.
11. Install the removed parts by reversing the
steps of removal.
n
. Install the right and left arms of the arm
assembly in parallel. Otherwise, the rear
cover (screen) may tilt.
. To make the right and left arms parallel, it
is recommended that you put the rear cover
vertically on a level object (such as desk)
and tighten setscrews to place the arms on
the horizontal surface.
HDVF-EL70/HDVF-EL75
Arm (R) sub
assembly
K3
6
P3
5
Lift lock shoe (F)
P3
B3
5
5
Setscrews
Rear cover
Arm
1-25
Advertisement
Table of Contents
