1-8-3. Arm (L) Sub Assembly
1. Perform steps 1 to 16 in "1-8-1. Harness (VF
Connection 1)" to pull the harness (VF Con-
nection 1 or VF Connection 2) out of the hole
in the arm (L) sub assembly.
2. Remove the three screws (B3 x 5) to detach
the lift friction plate (F).
3. Loosen the three setscrews.
4. Remove the two screws (K3 x 6) of the arm
(L) sub assembly.
5. Remove the four screws (P3 x 5) of the arm
(L) sub assembly.
6. While pulling the harness out of the hole in
the arm (L) sub assembly, remove the arm (L)
sub assembly from the shaft of the VF holder
sub assembly.
7. Install the removed parts by reversing the
steps of removal.
n
. Install the right and left arms of the arm
assembly in parallel. Otherwise, the rear
cover (screen) may tilt.
. To make the right and left arms parallel, it
is recommended that you put the rear cover
vertically on a level object (such as desk)
and tighten setscrews to place the arms on
the horizontal surface.
HDVF-EL70/HDVF-EL75
VF holder sub assembly
Harness
Shaft
Hole
P3
Lift friction plate (F)
Arm (L) sub assembly
K3
6
Setscrews
B3
5
5
Rear cover
Arm
1-23