Table of Contents
Advertisement
aloha eMule] <-MilemAeliliaiceies
Referring to the figure below, connect the VGA-5 and other devices as shown.
External Sound Module
Mixer
(Guitar Synthsizer etc.)
Stereo
Headphones
FOOT CONTROL
Roland GFISO
poor conrncacen
Foot Controller
SU
(GFC-50, FC-200 etc.)
Foot Switch (BOSS FS-5U etc.)
Expression Pedal
* The FS-5L can only be used for turning effects
(EV-5, BOSS FV-300L etc.)
on and off; it cannot be used for tapping.
The following equipment will add additional functionality to
* Use only the specified expression pedal (Roland EV-5, BOSS
your VGA-5 system.
FV-300L; optional). By connecting any other expression pedals,
¢
Foot Controller
you risk causing malfunction and/or damage to the unit.
(optional: Roland GFC-50, FC-200)
* When switching memories or using the delay tap, use the FS-
* Expression Pedal
5U (momentary type).
(optional: Roland EV-5, BOSS FV-300L)
* To prevent malfunction and/or damage to speakers or other
*
Foot Switch (optional: BOSS FS-5U/FS-5L)
devices, always turn down the volume, and turn off the power
* The FS-5L can only be used for some functions (p. 22).
on all devices before making any connections.
* Always be sure to turn [MASTER] down to "0" whenever
connecting or disconnecting headphones.
Turning the Power On and Off
Once the connections have been completed, turn on power to
* When this device is in operation, the cooling fins located on the rear
your various devices in the order specified. By turning on
panel will become hot. Take care not to touch them with your hands.
devices in the wrong order, you risk causing malfunction
* This unit is equipped with a protection circuit. A brief interval
and/or damage to speakers and other devices.
(a few seconds) after power up is required before the unit will
:
;
operate
no.
;
Device connected
Device connected
perate normally
> VGA5
>
to EXT IN
to LINE OUT
* Always make sure to have the volume level turned down before
F
se
.
switching on power. Even with the volume all the way down
* When the power is turned on, sound will be produced using
out
y
:
.
ee
you may still hear some sound when the power is switched on
the same settings in effect when the power was last turned off.
y
y
}
:
but this is normal, and does not indicate a malfunction.
15
Advertisement
Table of Contents
