Attaching And Removing The Casters - Roland VGA-5 Owner's Manual

IMPORTANT NOTES
¢ To avoid disturbing your neighbors, try to keep the unit's
volume at reasonable levels. You may prefer to use
headphones, so you do not need to be concerned about
those around you (especially when it is late at night).
¢ When you need to transport the unit, package it in the box
(including padding) that it came in, if possible. Otherwise,
you will need to use equivalent packaging materials.
¢ Use only the specified expression pedal (EV-5; optional).
By connecting any other expression pedals, you risk
causing malfunction and/or damage to the unit.
¢ Usea cable from Roland to make the connection. If using
some other make of connection cable, please note the
following precautions.
*« Some connection cables contain resistors. Do not use
cables that incorporate resistors for connecting to this
unit. The use of such cables can cause the sound level
to be extremely low, or impossible to hear. For infor-
mation on cable specifications, contact the manufac-
turer of the cable.
¢ To avoid injury, avoid placing hands at points indicated
by the arrows in the following figure.
¢ When this device is in operation, the cooling fins located
on the rear panel will become hot. Take care not to touch
them with your hands.
Attaching and Removing the
Casters
Attaching all of the casters can make it easier to move the
amplifier.
When using casters, take care not to allow fingers or other
parts of the hand or body to get pinched or injured.
it
Be sure to remove all casters when accidental movement may
be dangerous such as when setting up the VGA-5 on stage or
when transporting it in a vehicle.
0
If casters have been attached to the amp, make sure it is used
only ona stable, level surface.