Calling Up The Factory Tone Settings For Each Individual Bank; Problems: With The Sound Ccicih Hisses Cessed Aiseesde Fives. Gevesesdspacatessdavons Daeseessaghabstsedrtsdtusansdecasgteds Dee - Roland VGA-5 Owner's Manual

Appendices
Calling Up the Factory Tone Settings for Each Individual Bank
You ean select any one of the Banks 0-3 listed on the Memory Sheet (p. 32) and call up that bank's factory-loaded tone settings to
memory buttons 1-10.
SEE A Se ee TY na
MANUAL VG 2h 3/5 ao
Se) &)
(1) (2) (3) (4) (5) (6)
1. While holding down the memory button corresponding 2. Press [WRITE] (6).
to the bank on the Memory Sheet that you want to call The [WRITE] indicator flashes; once the settings have
up, switch ON the POWER switch. been called up, the VGA-5 returns to memory Number 1.
To call up the Memory Sheet Bank 0 tone settings: [1/6] (2) * Calling up these settings clears all of the Memories 1-10
To call up the Memory Sheet Bank 1 tone settings: [2/7] (3)
To call up the Memory Sheet Bank 2 tone settings: [3/8] (4)
To call up the Memory Sheet Bank 3 tone settings: [4/9] (5)
For example, if you want to call up the tone settings for
Bank 2 on the Memory Sheet, hold down [3/8] (4) and
switch the power on. The [3/8] indicator flashes.
previously stored in Bank 0.
* Ifyou want to cancel the operation, press [MANUAL] (1).
Problems With the Sound
This section explains some things that might go wrong when using the VGA-5, and what needs to be done to correct the
problem.If you think there may be something wrong with your VGA-5, please check through the following first. If these
suggestions don't fix the problem, then go ahead and contact the store you bought it from, or your nearest Roland Service Station.
Trouble with the Sound Internal Effects Not Being Applied
, @ Are the effects set to "OFF"?
Odd Sound / No Sound When Guitar Is Played > Whenan effect is set to "OFF," that effect is not added to
@ Is the value for the [MASTER], [GAIN], or [VOLUME] the sound. Set to "ON."
knobs, or for the [GAIN] or [VOLUME] settings stored
in the memory set to "0"?
> Raise the volume to a suitable level.
@ Is the effect level turned completely down?
> When delay or reverb level is set to the minimum
setting, the effect is not applied, and only the source
> Depending on the model selected with the Amp Type
switch (p. 16), no sound may be produced when [BASS], Interruptions in the Sound
[MIDDLE), and [TREBLE] are all set to "0." @ is the noise suppressor effect set near "10" (deep
@ Are you using an expression pedal? effect)?
~ There may be no sound produced when the pedal > Make a shallower noise suppressor effect setting (p. 13).
portion is set to the released position. Try operating the
pedal.
@ = ff controlling the volume with MIDI, was the MIDI
connection disrupted while the volume was set to
"0"?
> Reconnect the MIDI device and raise the volume, or turn
the VGA-5's power off and then on again.
PEST A cE Ea ae TS a Rik La IS SE TS Oe al |
29