Table of Contents
Advertisement
2023/05/01 14:32
Specify the range of the IP address that can access the machine by using Web Image Monitor.
You can limit access from the following protocols.
LPR, RCP/RSH, FTP, Bonjour, SMB, WSD (Device), WSD (Printer), WSD (Scanner)/DSM,
IPP, DIPRINT, RHPP, snmp, telnet, NBT
The machine also limits access from Web Image Monitor.
Log in to the machine as the network administrator from Web Image
Monitor.
Logging in to the Machine as the Administrator
Click [Configuration] on the [Device Management] menu.
Click [Access Control] in the [Security] category.
In "Access Control", click [Active] and specify the range of IP addresses
that have access to the machine.
To specify an IPv4 address, enter a range that has access to the machine in [Access Control
Range].
To specify an IPv6 address, select [Range] or [Mask] in "Access Control Range", and then enter a
range that has access to the machine.
Click [OK].
Log out of the machine, and then exit the Web browser.
Protocol Setting Method List
https://support.ricoh.com/services/device/ccmanual/IM_7000-8000-9000-re/en-GB/security/int/control.htm
Access Control | User Guide | IM 7000, IM 8000, IM 9000
2/12
Advertisement
Table of Contents
