Dahua IPC-HFW2431T-ZS-S2 Operation Manual page 106

Step 2 Select SNMP version to enable SNMP.
Select V1, and the system can only process information of V1 version.
●
Select V2, and the system can only process information of V2 version.
●
Select V3 , and then V1 and V2 become unavailable. You can configure user name,
●
password and authentication type. It requires corresponding user name, password
and authentication type to visit your device from the server.
Using V1 and V2 might cause data leakage, and V3 is recommended.
In Trap Address, enter the IP address of the PC that has MIB Builder and MG-SOFT MIB
Browser installed, and leave other parameters to the default.
Parameter
SNMP Port
Read Community, Write Community
Trap Address
Trap Port
Read-only Username
Read/Write Username
Authentication Type
Authentication Password
Encryption Type
Encryption Password
Click Save.
Step 3
Results
View device configuration through MIB Builder or MG-SOFT MIB Browser.
1. Run MIB Builder and MG-SOFT MIB Browser.
Table 4-27 Description of SNMP parameters
Description
The listening port of the software agent in the device.
The read and write community string that the software
agent supports.
You can enter number, letter, underline and dash to form
the name.
The target address of the Trap information sent by the
software agent in the device.
The target port of the Trap information sent by the software
agent in the device.
Set the read-only username accessing device, and it is
public by default.
You can enter number, letter, and underline to form the
name.
Set the read/write username access device, and it is public
by default.
You can enter number, letter, and underline to form the
name.
You can select from MD5 and SHA. The default type is
MD5.
It should be no less than 8 digits.
The default is CBC-DES.
It should be no less than 8 digits.
95
Operation Manual