Battery Replacement; Troubleshooting "Before You Call" Section - CrimeStopper Ezee Start EZ-30DP Operating Instructions Manual

Crimestopper security products operating instructions 1-way system dp series ii (data port) ez-30dp, ez-31dp, ez-33dp, ez-34dp
Hide thumbs Also See for Ezee Start EZ-30DP:
Table of Contents

Advertisement

TROUBLESHOOTING: "BEFORE YOU CALL" SECTION
VEHICLE STARTS BUT "CHECK ENGINE" LIGHT COMES ON OR ENGINE RUNS BADLY: (2 parts)
1. Many 1995-UP General Motors cars/trucks require a secondary ignition circuit for the Transmission computer
and other on board systems. If the vehicle is started without this wire energized, there may be a "Check Engine"
or "Service Engine Soon" light on the dash. This may cause damage if the vehicle is driven in this condition.
Check with installer to see if this circuit is present and has been properly connected to the system.
2. In some cases [commonly Nissan vehicles], an additional "Start" (Cranking) circuit is required for the vehicle to
run properly. The EZ-30 SERIES II system includes a wire that can be used for this Starter #2 circuit. Check
with your installer for details.
To replace the battery:
battery and replace. The replacement battery for all transmitters is GP23A.
REMOVE SCREWS

BATTERY REPLACEMENT

Simply remove the screws on back of the transmitter and open the case. Remove the
+
BATTERY
15
-
GP23A

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ezee start ez-33dpEzee start ez-34dpEzee start ez-31dp

Table of Contents