4.2 Mounting
Step 1. Install the mounting bracket
DANGER
1.The
walls
materials,othewise there is a fire risk.
2.Before drilling holes ,check whether there are electric power
pipes buried in the walls to avoid risks.
1 ) Use a horizontally ruler to mark the position of the 3 holes on the wall.
Refer to Step 1. And drill 3 holes, 10mm in diameter and 60 mm in deep.
Refer to Step 1 and Step 2.
2) Knock the expansion screw kit into the hole together with a hammer.
Refer to Step 3.
Note: Do not remove the nut unit.
3) After tightening 2-3 buckles, the expansion bolts are tight and not
loose, and then unscrew the bolts, spring washer, gasket. Refer to Step 3.
4) Install the bracket on the wall,the bracket screw is pointed at the
expansion tube on the wall, then install the gasket and tighten screw.
Refer to Step 4.
must
be
fileproof
and
non-flammable
14