Presentation Mode; Led Illumination - Presentation Mode; Presentation Led Behavior After Decode - Honeywell Vuquest 3320g User Manual

Presentation Mode

Presentation Mode uses ambient light and scanner illumination to detect bar codes. When in Presentation Mode, the LEDs
remain dim until a bar code is presented to the scanner, then the aimer turns on and the LEDs turn up to read the code. If the
light level in the room is not high enough, Presentation Mode may not work properly
Scan the following bar code to program your scanner for Presentation Mode.

LED Illumination - Presentation Mode

If you wish to set the illumination LED brightness, scan one of the bar codes below. This sets the LED illumination for the
scanner when it is in Presentation Mode. (If the scanner is triggered manually, the LED illumination will switch to the setting
for a manual trigger. (See
Note: The LEDs are like a flash on a camera. The lower the ambient light in the room, the brighter the LEDs need to be so
the scanner can "see" the bar codes.
Off
* High
Note: LED Illumination - Presentation Mode does not apply to
Mode.

Presentation LED Behavior after Decode

When a scanner is in presentation mode, the LEDs dim 30 seconds after a bar code is decoded. If you wish to dim the
LEDs immediately after a bar code is decoded, scan the LEDs Off bar code, below. Default = LEDs On.
* LEDs On
3 - 6
Presentation Mode
LED Illumination - Manual Trigger on page 3-5.) Default = High.
Streaming Presentation™ Mode
Low
or Mobile Phone Read
LEDs Off