Training - Dog trace X25 Series Manual

Transmitter information panel – bottom line shows data relating to the next
paired transmitter in sequence – battery charge status, RF signal strength, GPS
position accuracy.
NOTE: If the dog's direction and distance indicator flashes, the receiver has not
received the GPS data for a long time or the receiver/transmitter has no GPS
signal. In such case, the direction and distance to the last known position is
indicated on the display.
WARNING: If the direction indicator does not point correctly towards your dog,
recalibrate the digital compass.
Status indicated on the receiver's display:
– Receiver has not received information from the transmitter relating to
the dog's position for a long time.
– If the RF signal strength indicator flashes, it signifies that it has received
location data from the selected collar.
– If only the RF aerial flashes – it does not receive any RF signal from the transmitter.
– Receiver or transmitter does not have the GPS position.
– No paired transmitter at the given position.
– Receiver and transmitter are closer to each other than the accuracy of the
GPS position.

8.2 Training

This feature enables correction of undesirable behaviour up to the distance of
20 km. The basic DOG GPS X25/X25B kit enables using the acoustic command.
DOG GPS X25T/X25TB (training) kit is enhanced by the use of the correction
stimulation impulse. Another feature of the training kit is the light indication of the
dog in the dark with the aid of powerful LEDs.
Acoustic signal (tone):
All kits in the X25 series enable two types of acoustic signal.
The training acoustic signal (
may precede the stimulation impulse and it is a very effective deterrent. Replaces
whistle, whose volume the dog perceives in the same manner, even though it is far
away.
Localisation (
dark or in dense vegetation. This signal is audible up a distance of 30 m (X25/X25T
transmitters) or up to a distance of 300 m (X25B/X25TB transmitters).
Training acoustic signal is activated by the
pressing + push buttons simultaneously.
For the X25B and X25TB transmitters, the volume of both types of acoustic signal can
be set in the receiver MENU.
For the X25/X25T/X25B/X25TB transmitters, the tone of both the training and
localization signals can be changed.
1. Long press the MENU push button.
2. Select the
) is used as the sound command, which
) acoustic signal is used to locate a dog in the
push button and location sound by
item by using / arrows; long press the MENU
17